[hcflinux] Compilation failure with version 1.10full

Linuxant support (Jonathan) support at linuxant.com
Tue Mar 7 10:44:10 EST 2006


after you have installed the patch, please make sure that you did 
re-install the software with the following commands in the root 
directory of the source package:

make uninstall clean install


Technical specialist / Linuxant
support at linuxant.com

Alex Lancaster wrote:
>>>>>>"J" == Linuxant support (Jonathan)  writes:
> J> Hi, the patch will be applied to the HCF PCI driver and not the
> J> kernel, so you do not have to re-compile your kernel.
> Thanks, I followed the instructions and downloaded the tar.gz file,
> then did a "make install", followed by a
> sudo /usr/sbin/hcfpciconfig --patch
> which downloaded the swsusp2 patch, then it attempted to build the
> kernel module, but again failed with a different error message (I have
> attached the build log at the end of the e-mail):
>  Conexant HCF controllerless PCI modem driver, version 1.10full
>  If you need license keys, assistance or more information, please go
>  to:
>          http://www.linuxant.com/
>  When reporting a problem for the first time, please send
>  us the file generated by "hcfpciconfig --dumpdiag".
>  No pre-built modules for: Fedora-4
>  linux-2.6.13-1.1528_FC4_akl1_swsusp2 i686
>  Trying to automatically build the driver modules...
>  (this requires a C compiler and proper kernel sources to be installed)
>  Where is the linux source build directory that matches your running
>  kernel?
>  [/lib/modules/2.6.13-1.1528_FC4_akl1_swsusp2/build]
>  Building modules for kernel 2.6.13-1.1528_FC4_akl1_swsusp2, using
>  source directory
>  /lib/modules/2.6.13-1.1528_FC4_akl1_swsusp2/build. Please wait...
>  ERROR: Module build failed!
>  Please examine the log file "/tmp/hcfpciconfig-buildlog.txt" to
>  determine why.
> J> According to the information you have provided for your other
> J> modem, I can't confirm if it will be supported or not by the HSF
> J> modem driver. The HSF modem driver only supports modems based on a
> J> Conexant HSF chipset. If the modem is not based on a Conexant HSF
> J> chipset, an error message stating so will be left in your 'dmesg'
> J> after you have installed the right driver package for your system.
> Thanks,
> Alex
> _______________________________________________
> hcflinux mailing list
> hcflinux at lists.linuxant.com
> https://www.linuxant.com/mailman/listinfo/hcflinux

More information about the hcflinux mailing list