[hsflinux] read_size patch displays an error

Christophe TROESTLER Christophe.Troestler at umh.ac.be
Fri Nov 10 19:47:23 EST 2006


I installed the full HSF driver on a kernel.  After the first
"make install", I then used "hsfconfig --patch" to install the patches
- snd_pcm_hw_param_set
- read_size
The installation of "read_size" produced the following error message:

  Downloading the file 'http://www.linuxant.com/drivers/hsf/full/archive/patches/hsf-', please wait... done.
  Patching... failed.
  ERROR: Failed to install patch 'hsf-'. Output from the 'patch -p1' command:
  patching file modules/GPL/hda/hda_proc.c
  patching file modules/Makefile
  Hunk #1 FAILED at 100.
  1 out of 1 hunk FAILED -- saving rejects to file modules/Makefile.rej

and re-running "hsfconfig --patch" shows the patch as NOT being
installed.  It is however as doing "make install" followed by
"hsfconfig" detects the modem.

It would be nice if this was corrected as it is not clear the error
must be disregarded -- it caused me hours of frustration.


More information about the hsflinux mailing list