[driverloader] usr 805410 and latest drivers (5.0j)
Cristiano De Michele
demichel at na.infn.it
Sat May 8 15:46:40 EDT 2004
On Sat, 2004-05-08 at 14:29, Marc Boucher wrote:
> Hi Cristiano,
> 1) The advanced settings are controlled by the Windows driver's inf
> In USR's new driver, the definitions for some parameters, like Mode4x,
> have been commented out; that's why they no longer appear on
> driverloader's advanced settings page. But in the case of Mode4x, the
> default value seems On.
this means I can remove comments and have settings back?
> 2) We have done a few tests here sending data to an USR5450 AP (running
> the latest 1.41 firmware) with turbo mode enabled, and it seems to work
> fine - haven't been able to reproduce any hangs. What brand/model of AP
> and firmware revision do you have? How much data can you send before
> the problem happens? Does it happen when receiving data too?
it happens only on sending data and my AP is a USR808054 with latest
1.21h firmware, could it matter?
moreover kernel on my laptop is 2.4.25.
> Have you
> tried resetting the configuration parameters (rm -f
> /etc/driverloader/config/*; dldrstop; dldrconfig -i) to defaults?
no I'll do and I'll let you know...
> 3) The led also stays on with the new driver when disabling/ejecting
> the card under Windows . Seems like a benign issue.
ok good to know
thanks for your reply
> On May 6, 2004, at 4:47 PM, Cristiano De Michele wrote:
> > Hi,
> > I tried to use latest driver (v5.0j) for my pcmcia card (USR805410)
> > from www.usr.com with driverloader but I had following problems
> > to report:
> > 1) As I installed 5.0j driver I had less advanced settings in
> > driverloader configuarion html page (not mode4x for example
> > and many others)
> > 2) If turbo mode is enabled on AP, as I send data
> > from laptop (equipped with usr805410) to AP the transfer rate
> > goes quickly to 0 and network interface hangs completely (I have
> > to reload driveloader module to make it work again)
> > 3) if I do dldrstop the power led of the pcmcia card does not turn off
> > fortunately drivers from
> > http://www.linuxant.com/driverloader/drivers.php
> > work perfectly and actually I'm using them
> > but I'd like to hear from if there is any hope
> > to have driver v5.0j working with driverloader,
> > thanks,
> > Cristiano
> > --
> > Cristiano De Michele E-mail:
> > cristiano.demichele at phys.uniroma1.it
> > Department of Physics Tel. : +39064457131
> > University of Rome "La Sapienza" Fax : +39064463158
> > Piazzale Aldo Moro 2
> > I-00185 Roma - Italy
> > ------
> > "Shoot for the moon. Even if you miss, you'll land among the stars."
> > _______________________________________________
> > driverloader mailing list
> > driverloader at lists.linuxant.com
> > https://www.linuxant.com/mailman/listinfo/driverloader
> driverloader mailing list
> driverloader at lists.linuxant.com
Cristiano De Michele E-mail: cristiano.demichele at phys.uniroma1.it
Department of Physics Tel. : +39064457131
University of Rome "La Sapienza" Fax : +39064463158
Piazzale Aldo Moro 2
I-00185 Roma - Italy
"Shoot for the moon. Even if you miss, you'll land among the stars."
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Size: 189 bytes
Desc: This is a digitally signed message part
Url : http://www.linuxant.com/pipermail/driverloader/attachments/20040508/9d47c008/attachment.bin
More information about the driverloader